• Zoning is included in the building application.
• Building Plan Review Required before permit is issued, application and plans to be submitted to the Permit Clerk.
• Footer – Inspection when forms are set, and re-bar is in place and BEFORE concrete is poured.
• Holes/piers – Inspection BEFORE poles are set or per instructions from Inspector.

Note: ICF, PWF, Superior wall foundations may require additional footer inspections, check with inspector.

• Backfill – Inspection when drain tile and foundation coating are applied below grade. Drain tile is to be below top of floor with a minimum of 6” of pea stone surrounding the tile. (heated structures and attached garages require 6 mil plastic below floor)
• Underground for Electrical, Mechanical or Plumbing
• Frame – inspection prior to siding and subtrades (electrical, mechanical, or plumbing)
• Rough – inspection after sub-trades rough inspections is approved. For mobile homes (tie downs), bedrooms require egress to exterior of dwelling and all basements require one (1) egress window or door.
• Insulation – inspection before wall or ceiling coverings are installed. Walls R-21, Ceiling R-38, Foundation R-10, Floor R-10.
• Final – Prior to inspection, the following must be completed:
  • All final inspections for Electrical, Mechanical and Plumbing permits.
  • Smoke/CO2 detectors must be installed to code where required.
  • Guardrails/handrails installed where required.
  • House number posted/installed and visible from the road.
  • Mobile homes must have all tie-downs, smoke detectors, fire extinguishers and all skirting installed.
  • Final grades 6” fall to distance of 10”, cannot flow water to adjoining properties.